Auto Salvage Yard & Used Parts
Closed from 11/16/2020 - 11/30/2020
due to crushing and inventory audit
scroll to the bottom of the page for a downloadable copy of our warranty information
Warranty covers the Long Block (Engine Block, Cylinder Heads, Head Gasket(s), Crankshaft, Pistons, Rods, Bearings, Oil Pump, Camshaft(s), Valves & Lifters).What is Covered: Engine warranties are limited to manufacturing defects in the Engine Block, Cylinder Head(s), Head Gasket(s), Crankshaft, Pistons, Rods, Bearings, Oil Pump, Camshaft(s), Valves & Lifters. What is NOT covered or guaranteed to be included: The engine you receive may or may NOT include some additional accessories and extra parts. If included these parts are sold AS-IS with NO WARRANTY. Examples of these non-warranty parts include switches, sensors, cables, coils, wires, injectors, electronics, belts (including timing belt/chain), hoses, water pumps, brackets, intake/exhaust manifolds, oil pans and turbos/superchargers (if equipped).
Engine Installation Check List:
(Failure to complete the following will void Warranty)
Determine why the original engine failure occurred and make appropriate repairs including clearing all diagnostic codes prior to instillation. Insure this engine is the same application as the one being replaced. Inspect and replace gaskets & seals (front seal, rear main seal, valve cover gaskets, oil pan gaskets) & Install new thermostat & gasket (warranty will be void if engine heat tab is melted or removed)Replace the timing belt , water pump, sparkplug & wires. Exchange attached accessory items to insure proper fit (mounts, intake manifold, exhaust manifold, distributor, sensors). Replace engine oil, oil filter, air filter, fuel filters, and coolant-antifreeze. If equipped with an engine oil cooler the radiator or external cooler must be replaced.
Warranty covers the transmission case, torque converter (included for automatic transmissions only) and all internal components. The warranty does not cover any external wiring, sensors or other external parts that can be transferred from your current transmission. What is NOT Covered: It is the responsibility of the installer to replace the radiator or transmission oil cooler, flush the transmission oil cooling lines, fill differential, adjust shifter mechanisms, replace external switches sensors & solenoids, replace all filters, replace all seals, replace pan gaskets and Relearn, Reset or Replace computers and clear all codes when installing a transmission. Transfer cases are not included with transmission from AWD vehicles.
Transmission Installation Check List
(Failure to complete the following will void Warranty)
Determine why the original transmission failure occurred and make appropriate repairs, clear all transmission computer codes in the vehicle prior install. Insure the part is the same as the one to be replaced. Remove oil pan and replace filter, Replace front seal. Inspect and replace rear seal as needed. Remove torque converter strap. Properly install and index the torque converter completely into the front pump. Change over sensors as needed. Flush the transmission cooler lines and radiator with a power flush machine or with an aerosol 'Cooler Flush Kit'. This will ensure the cooling system is flowing. Most 4WD & some 2WD vehicles must re-learn the shift logic to the transmission after installation. You may verify with your local dealer if a re-learn is required for your vehicle. We do not reimburse for this service.
Differential/Carrier parts such as the ring gear, spider gear, side gear, pinion shaft, drive pinion gear, and the ring and pinion assembly are covered under warranty unless bought AS-IS or noted otherwise on invoice. Parts such as axle seals, brake parts, ball joints, inspection plate, backing plates, wheel bearings, and bushings related to steering and suspension components are NOT covered by our warranty and should be inspected and replaced as needed by the installer. The warranty is void if the vehicle is used in a fleet, taxi, commercial vehicle, or is used for racing or other competition or off-road recreational purposes.
We guarantee the wheel to be good at time of purchase. We only guarantee wheel to not be bent or cracked. We do not guarantee seal. Wheel may need refinishing prior to installation. Some wheels may include Tire Pressure Monitor Sensors (TPMS) and/or tire. If included, TPMS and/or tires are sold AS-IS with NO warranty. The price of the listing is for the wheel(s) ONLY. We do NOT sell or guarantee tires, inspect and use at your own risk.
Suspension parts are sold AS-IS with NO warranty. Parts such as leaf springs, coil/air springs, hub assemblies, brake rotors, struts, control arms, spindles, cradles, calipers, steering gear racks, stabilizer bars, drive shafts, and other miscellaneous suspension items should be inspected at time of purchase. Axle boots, tie rod ends, bushings, ball joints, bearings, and hubs should be replaced as needed by the installer. The warranty is void if the vehicle is used in a fleet, taxi, commercial vehicle, or is used for racing or other competition or off-road recreational purposes.
If equipped and activated, it is the buyer's responsibility to obtain the code from the dealer. The donor vehicle VIN will be included on the invoice to help obtain the code from the dealer. There is a chance the dealer may charge a service fee to obtain the code. Wiring harnesses, GPS Antennas & VIN locking protection are just a few factors that may prevent you from upgrading certain types of radios in your vehicle. You are 100% responsible for making sure you will be able to make an upgrade. If we have listed years and makes for a radio you are purchasing, that is all it is guaranteed to fit. We cannot tell you if it fits anything else. Please do not ask because you will only get this statement as a reply. Just because it looks like it will fit, doesn't mean it will.